Renesas Flash Programmer (Programming GUI)

infoAdditional Details

Functions

• Supported file formats for programming: Intel HEX for HEX and HCUHEX files, Motorola S for HEX and HCUHEX files, and RPI for RPI file
• Check sum of program files
• Blank check, erase, writing, verification, read-out, security setting, checksum, autoprocedure, setup and acquisition of flash options
• Sequential execution of multiple commands (for erasure, programming, verification, etc.)
• Multiple files for programming selectable simultaneously

Enhanced security against theft through the encryption of program files

The new function for encrypting program files enhances security against theft.
You can run this function by using the encryption utility program (RPE.exe) from the command line. The file is among those installed by the Renesas Flash Programmer installer.

Image

Easier Creation of Projects

Easy selection of type names

No need to select detailed type names for products of the RL78 family.

Image

Easy setting of mode pins for RX family products

No need for mode pin setting, when the recommended connection examples are used.

Image

The system configuration in programming with Renesas Flash Programmer V3 is as follows.

Image

Note:

1. The E1 emulator is also usable.
2. Renesas Flash Programmer can use certain models of Segger J-Link to provide a serial communication with the boot mode functionality of RA Family MCUs. Please refer to the Renesas Flash Programmer Information for Users for applicable hardware, recommended firmware, appropriate debug connection to the target MCUs.

Target Devices by Connection Methods

For the details, refer to List of MCUs supported by Renesas Flash Programmer V3 (PDF | English, 日本語).

lens Available | — Not Available

Note:

1. When using with the on-chip debugging emulators, conversion adapter is required depending on the number of pins on the target board.