Due to the ongoing remote work, it is sometimes difficult to ask for the help of a colleague with more experience and knowledge in a particular topic. Do you know that you can rely on our video portal site that shows you how to use the development environment for RX family in such a case?
Even if you know that both the capacitive touch keys and cloud services can be realized with the RX MCU, you might be troubled over where to start for the first time. Therefore, we have published the video portal site to help with information that is easy to find, easy to watch, and easy to understand. For example, you can find and learn about the below topics:
- How to install and use the e2 studio IDE for the RX family development
- I have purchased a Cloud Kit but how can I set up the kit?
- Implementation of the capacitive touch key seems to be difficult. Do you have an easy learning guide on this topic?
Do you face similar challenges at the start of development?
Then, we can help you address this by referring to the Renesas video portal on how to use the Renesas development environment. For example, you can learn about the basics of the capacitive touch key development in just 15 minutes.
Q. How to install and use the e2 studio IDE for the RX family development?
A. Please refer to the video on installation and creation of a project to debugging on the e2 studio.
Q. I have purchased a Cloud Kit but how can I set up the kit?
A. Please refer to the video on how to get connected to the AWS Cloud using the RX65N cloud kit in 3 easy steps. The video on Azure RTOS is also available.
Q. Implementation of the capacitive touch key seems to be difficult. Do you have an easy learning guide on this topic?
A. We have prepared the video for self-learning the capacitive touch key in 3 easy steps: driver setting, capacitive touch sensitivity tuning, and monitoring.
These videos are categorized by the solution for easy finding, and the short videos are summarized by the function for easy watching and understanding.
Other than these videos, we have prepared the videos for the Tool Introductory Course (from installation to debug on e2 studio) and solution-related videos such as graphic user interface, motor, Bluetooth Low Energy, security, and voice recognition. We are going to add more videos to this portal. Please stay tuned!