Support Communities
-
I2c SLC signal on pin 512
Hello, I'm currently trying to see the SLC signal on pin 512 (SKG2 board) on the oscilloscope. The project that i'm using is the I2C_HAL_MG_AP provided by Renesas. However when the program is executing and i put the oscilloscope tip on the pin 512, the ...
Jan 31, 2018 -
Read long characteristic response limited to 512 bytes
... does compile but does NOT run on the device. SIZE_OF_DATA_BLOCK 512 works fine Now my questions is twofold: 1. where is this 512 bytes limit defined? 2. some thought has gone into setting this limit, question is, why 512? And what are the dragons I'll face ...
Jun 2, 2017 -
Can we increase the MTU size from 251 to 512 for DA14531 MOD?
Hi Renesas, iam using code Less version: 6.380.14.22. Can we increase the MTU size from 251 to 512 for DA14531 MOD? Regards, Laxmi Narayana.
Apr 22, 2024
Knowledge Base
-
I would like to set a program at 40000h to 7FFFFh in ROM 1 over 512 KB.
For products with the size of program ROM 1 over 512 KB, addresses 40000h to 7FFFFh are disabled (used as a reserved area) after a reset. To enable addresses 40000h to 7FFFFh, you must set internal area expansion bit 0 (PM13) in the PM1 register and internal area expansion bit ...
Feb 24, 2012 -
How to use images bigger than 512
Document explaining how to configure the SDK to run images larger than the default 512kBSupporting Images Bigger than 512 kB — getting_started (renesas.com)
Oct 17, 2024 -
Why does the ISL9111 not start up when power is reconnected?
Question: When I disconnect the input power (battery) and then reconnect it, the ISL9111 will not start up unless I wait almost 20 seconds before reapplying power. Please explain what is going on and how to reduce this time. Answer: If you are using the exact schematic from the data ...
Support Communities
