Renesas Electronics Corporation - June is Pride Month, a month to raise awareness of the rights and the culture of the LGBTQ+ community

Refine

Applied Filters
Additional Search Tools
  • Boards & Kits
  • Software & Tools
  • Document Search
  • Cross Reference
    • 1 result found for "83037"
    1. Support Forums
      Unable to control some pins
      Sep 19, 2019
      Hi PM_Dialog, I recently have some diffculties during developing the program on the proDK. In my program, I use the P0_14 and P0_15 as I2C or GPIO function instead of USB function. But the pins can't generate any signal and even can't read/set the...

    Knowledge Base

    1. Can we transfer first MSB to LSB to register smart card interface?
      Yes, it will. The LSB/MSB-first function of smart card interface is directly usable in the serial interface. *Note: H8/300H only.
    2. How to output 8 clocks to receive data continuously?
      When the serial interface of the H8 family and the H8S family fulfills three conditions, which is in synchronous, set to SCK output, and in receive mode (TE=0, RE=1), the SCK output will be in a continuous output state in order to be able to recei...
    3. Why does an error occurs in asynchronous mode when starting RxD pin?
      For the serial interface in the H8 and H8S family, when a receive pin (a RxD pin) is low, start the receive operation to receive a break signal at the time the low pin was detected. Next, a framing error occurs when the serial interface could not ...

    Support Communities

    1. Unable to control some pins
      Sep 19, 2019
      Hi PM_Dialog, I recently have some diffculties during developing the program on the proDK. In my program, I use the P0_14 and P0_15 as I2C or GPIO function instead of USB function. But the pins can't generate any signal and even can't read/set ...
    Loading