Renesas Electronics Corporation - June is Pride Month, a month to raise awareness of the rights and the culture of the LGBTQ+ community

Refine

Applied Filters
Additional Search Tools
  • Boards & Kits
  • Software & Tools
  • Document Search
  • Cross Reference
    • 1 result found for "69808"
    1. Support Forums
      Connect without Scan ?
      May 07, 2016
      Device A and Device B advertising some measurement data every 10 Seconds. Every hour Device A has to exchange some data with Device B. So on Device A I change the role to a Master - scan for Device B - connect to Device B - exchange Data - change ...

    Knowledge Base

    1. What the setting to change to the DSP arithmetic mode?
      The DSP arithmetic mode is set by bit 12(DSP bit) of status register (SR). When DSP bit = "1" is set, the DSP instruction becomes effective.
    2. What steps should be taken to ensure correct operation of the device?
      Be sure to connect Vcc-RTC and Vss-RTC to a power supply even when not using RTC. Do not connect anything to XTAL2. SH7709S, SH7729R, SH7706, SH7727: Please pull up EXTAL2 to Vcc (Internal Power supply). SH7705: Please pull up EXTAL2 to VccQ (I/O ...
    3. Which registers are initialized by a power-on reset of WDT?
      FRQCR,WTCNT and WTCSR are not initialized. Other registers depend on a power-on reset and a manual reset. For details, please refer to register descriptions of the hardware manual.

    Support Communities

    1. Connect without Scan ?
      May 07, 2016
      Device A and Device B advertising some measurement data every 10 Seconds. Every hour Device A has to exchange some data with Device B. So on Device A I change the role to a Master - scan for Device B - connect to Device B - exchange Data - change ...
    Loading