Overview
Design & Development
Support
Support Communities
Get quick technical support online from Renesas Engineering Community technical staff.
Resources
Support Communities
-
Possible to determine, at runtime, if code is executing on M16C/5LD or M16C/56D?
... other instances we do not use the CAN at all. For reasons out of my control we now need to use a MCU from the M16C/56D group now for a batch of devices. From what I have understood from the datasheet the MCU from the M16C/56D ...
Sep 17, 2020 -
How to read MCU R5F35633JFF
Good I'm new here, best regards. Who could guide me in reading this mcu. This mcu is mounted on a motorcycle ecu. I await your prompt responses. Thanks in advance.
Oct 28, 2022
FAQs
-
(M16C Family products other than the M32C/80 Series, and the M16C/80 Series) Priority level is "0" + Request bit is "1": Priority level to "7"?
The interrupt will be accepted. Then, the interrupt request bit will be cleared. However, if you use the MOV instruction to change the interrupt priority level, the interrupt request bit may be cleared to "0". The interrupt will not be accepted when the interrupt request bit is cleared at this ...
Feb 14, 2006 -
(M32C/80 Series, M16C/80 Series) Priority level is "0" + Request bit is "1": Priority level to "7"?
The interrupt will be accepted. Then, the interrupt request bit will be cleared. However, if you use the MOV instruction to change the interrupt priority level, the interrupt request bit may be cleared to "0". The interrupt will not be accepted when the interrupt request bit is cleared at this ...
Feb 28, 2012 -
(M16C,M32C) Are there any hardware precautions for accurate A/D conversion?
In order to perform A/D conversion, it is necessary to fully charge the internal capacitor, but if the impedance of the A/D conversion target is high, the discharge and charge will take time and the conversion value will not be accurate. For correct A/D ...
Feb 27, 2012