Overview
Description
The F2270 is a low insertion loss Voltage Variable RF Attenuator (VVA) covering a broad frequency range from 5MHz to 3000MHz. In addition to providing low insertion loss, the F2270 provides excellent linearity performance over its entire voltage control and attenuation range. The device uses a single positive supply voltage of 3.15V to 5.5V. Other features include the VMODE pin allowing either positive or negative voltage control slope vs. attenuation and multi-directional operation, meaning the RF input can be applied to either RF1 or RF2 pins. Control voltage ranges from 0V to 5V using either positive or negative control voltage slope.
Features
- Low Insertion Loss: 1.1dB at 300MHz
- Typical/Minimum IIP3 > 50MHz: 62dBm/46dBm
- Typical/Minimum IIP2 > 50MHz: 98dBm/77dBm
- Up to 35dB attenuation range
- Bidirectional RF ports
- +36dBm input P1dB compression
- VMODE pin allows either positive or negative attenuation control response
- Linear-in-dB attenuation characteristic > 50MHz
- Supply voltage: 3.15V to 5.50V
- VCTRL range: 0V to 5.0V
- +105 °C maximum operating temperature
- 3mm x 3mm, 16-QFN package
Comparison
Applications
Documentation
Featured Documentation
Log in required to subscribe
|
|
|
|
|---|---|---|
| Type | Title | Date |
| Datasheet | PDF 4.69 MB | |
| Guide | PDF 2.24 MB | |
| Product Brief | PDF 395 KB | |
| Product Change Notice | PDF 5.71 MB | |
| Product Change Notice | PDF 5.61 MB | |
| Product Change Notice | PDF 51 KB | |
| Application Brief | PDF 686 KB | |
7 items
|
||
Design & Development
Boards & Kits
Evaluation
F2270EVBI
Active
Evaluation Board for F2270, 75 Ohm, Voltage Variable RF Attenuator
The F2270EVBI is a fully populated evaluation board which allows the customer to easily evaluate the F2270 Voltage Variable Attenuator. Attenuation slope may be set to either positive or negative attenuation slope using the on-board jumper pins.
Recommended Documents:
Models
ECAD Models
Schematic symbols, PCB footprints, and 3D CAD models from SamacSys can be found by clicking on the CAD Model links in the Product Options table. If a symbol or model isn't available, it can be requested directly from SamacSys.
Product Options
Applied Filters: