Overview
Description
The MCU unit is a MCU-dependent hardware tool for the E100 emulator. Connecting it to the E100 emulator main unit allows you to configure a debugging environment for your target system. It is easy for the user to replace. [Learn More]
Target Devices
Support
Support Communities
Get quick technical support online from Renesas Engineering Community technical staff.
Additional Details
Specifications
| Item | Description |
|---|---|
| Applicable emulator | E100 |
| Supported MCUs | M16C/50 Series
|
| Applicable MCU mode | Single-chip mode |
| Maximum ROM/RAM capacity | (1)Internal flash ROM : 284KB 0E000h--0FFFFh : Data flash (8KB) 10000h--13FFFh : Program ROM2 (16KB) 14000h--14FFFh : E2 Data flash (4KB) C0000h--FFFFFh : Program ROM1 (256KB) (2)Internal RAM : 20KB 00400h--053FF |
| Maximum operating frequency | Power supply voltage: 2.7--5.5[V] 25MHz (with PLL) 3.0--5.5[V] 32MHz (with PLL) |
| Emulator power supply | Supplied from the DC power of the emulator |
| Overseas standards | ・European Standards: EN 55022 Class A, EN 55024 ・US FCC Standard: FCC part 15 Class A |
Note:
- There are following limitations when using the emulator.
- (1) When using the emulator, the I/O port P8_5 is an N-channel Open-drain output. A 510kΩ pull-up resistor is connected to the P8_5 in the emulator. Please refer to R0E535M00MCU00 release notes and user's manual for details.
- a) M16C/5L, M16C/56 Groups (I/O port : CMOS output)
When using the I/O port P8_5 as an output port, an external pull-up resistor of the VCC level is needed on the user system. - b) M16C/5M, M16C/57 Group (I/O port : N-channel Open-drain output)
Set the value of the the pull-up resistor for the I/O port P8_5 up to the VCC level.
- a) M16C/5L, M16C/56 Groups (I/O port : CMOS output)
- (2) The functions of the multi-master I2C-bus interface and LIN module have limitations when using the emulator. Please see R0E535M00MCU00 Release Notes (E100 Emulator MCU Unit for M16C/5M M16C/5L M16C/56 M16C/5LD and M16C/56D Groups) (PDF | English, 日本語) and R0E535M00MCU00 User's Manual (E100 Emulator MCU Unit for M16C/5M, M16C/5L, M16C/56, M16C/5LD, and M16C/56D Groups) Rev.6.02 (PDF | English, 日本語) for further details.
- (1) When using the emulator, the I/O port P8_5 is an N-channel Open-drain output. A 510kΩ pull-up resistor is connected to the P8_5 in the emulator. Please refer to R0E535M00MCU00 release notes and user's manual for details.
Components
- MCU unit (R0E530650MCU00)
- Flexible cable (Mounted on the MCU unit)
- 20MHz oscillator module (Mounted on the MCU unit)
- CD-ROM (M16C R8C E100 emulator software)
- M16C R8C E100 emulator debugger (Including High-performance Embedded Workshop)
- Auto-update utility
- User's manual