The 8T49N028 is a low RMS phase jitter Clock Synthesizer with selectable internal crystal oscillator or external clock references and eight outputs, configurable as either LVDS, LVPECL or High Impedance.
After power up, two frequency select pins determine one of up to four different sets of factory preprogrammed crystal or input frequency and output frequency configurations. From a single input reference, as many as three different output frequencies may be selected for the output banks: two of these frequencies can be generated by the internal crystal oscillator, and/or external clock pre-divider, and/or A output divider, and/or B output divider. The third output frequency is from the B output divider. Device pre-programming can be overwritten through the provided I2C interface.
Examples of valid frequency configuration setups illustrate this device's flexibility, and are shown in Table 3A. The specific internal register settings for each of the four frequency sets are specified by a Renesas order code. Custom codes can be provided by contacting Renesas.
特性
Fourth Generation FemtoClock NG PLL technology
Eight selectable LVPECL or LVDS outputs (bank selectable, two output channels per bank)
CLK, nCLK input pair can accept the following differential input levels: LVPECL, LVDS, HCSL
FemtoClock NG VCO Range: 1.92GHz–2.5GHz
Bank A and B output frequencies are mux selectable from internal crystal oscillator, reference clock input, output divider A or output divider B
Clock from OUTPUT DIVIDER A, RMS phase jitter at 156.25MHz
(12KHz–20MHz): 225fs (typical)
Clock from OUTPUT DIVIDER B, RMS phase jitter at 156.25MHz
(12KHz–20MHz): 219fs (typical)
Clock from OUTPUT DIVIDER B, RMS phase jitter at 156.25MHz
(10kHz–1MHz): 165fs (typical) Full 2.5V or 3.3V power supply
Full 2.5V or 3.3V power supply
I2C programming interface
PCI Express (2.5Gb/S), Gen2 (5Gb/s) and Gen3 (8Gb/s) jitter compliant
-40°C to 85°C ambient operating temperature
Lead-free (RoHS 6) packaging
产品对比
应用
文档
设计和开发
模型
ECAD 模块
Schematic symbols, PCB footprints, and 3D CAD models from SamacSys can be found by clicking on products in the Product Options table. If a symbol or model isn't available, it can be requested directly from the website.