ISL8033AEVAL1Z

Dual 3A Low Quiescent Current High Efficiency Synchronous Buck Regulator Evaluation Board

Description

The ISL8033AEVAL1Z kit is intended for use by individuals with requirements for Point-of-Load applications sourcing from 2.85V to 6V. The ISL8033AEVAL1Z evaluation board is used to demonstrate the performance of the ISL8033A low quiescent current mode converter.

Key Features

  • Dual 3A High Efficiency Synchronous Buck Regulator with up to 95% Efficiency
  • 180° Out-of-Phase
  • Power-Goods (PG) Output with 1ms Delay
  • 2.85V to 6V Supply Voltage
  • 2% Output Accuracy Over-temperature/Load/Line
  • Start-up with Pre-biased Output
  • Internal Digital Soft-Start - 1.5ms
  • Soft-Stop Output Discharge During Disabled
  • External Synchronization up to 6MHzTypical 8µA Logic Controlled Shutdown Current
  • 100% Maximum Duty Cycle for Lowest Dropout
  • Internal Current Mode Compensation
  • Peak Current Limiting, Hiccup Mode Short Circuit Protection and Over-temperature Protection
  • Negative Current Detection and Protection

Applications

  • DC/DC POL Modules
  • µC/µP, FPGA and DSP Power
  • Plug-in DC/DC Modules for Routers and Switchers
  • Test and Measurement Systems
  • Li-ion Battery Power Devices
  • Bar Code Readers

ISL8033AEVAL1Z Buck Regulator Evaluation Board

ISL8033AEVAL1Z Buck Regulator Evaluation Board

 

Related Products

ISL8033

ISL8033A

Tool Information

No data found.

No product that matches the specified status or spec was found.
Please contact Renesas Electronics support

Disclaimer: THIS MATERIAL IS PROVIDED “AS-IS” FOR EVALUATION PURPOSES ONLY. RENESAS ELECTRONICS CORPORATION AND ITS SUBSIDIARIES (collectively, “Renesas”) DISCLAIM ALL WARRANTIES, INCLUDING WITHOUT LIMITATION, FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY. Renesas provides evaluation platforms and design proposals to help our customers to develop products. However, factors beyond Renesas' control, including without limitation, component variations, temperature changes and PCB layout, could significantly affect the product performance. It is the user’s responsibility to verify the actual circuit performance.