M16C/62T

FAQs

1. (M16C Family products other than the M32C/80 Series, and the M16C/80 Series) Priority level is "0" + Request bit is "1": Priority level to "7"?

   The interrupt will be accepted. Then, the interrupt request bit will be cleared. However, if you use the MOV instruction to change the interrupt priority level, the interrupt request bit may be cleared to "0". The interrupt will not be accepted when the interrupt request bit is cleared at this ...

   Feb 14, 2006
2. (M16C,M32C) Are there any hardware precautions for accurate A/D conversion?

   In order to perform A/D conversion, it is necessary to fully charge the internal capacitor, but if the impedance of the A/D conversion target is high, the discharge and charge will take time and the conversion value will not be accurate. For correct A/D ...

   Feb 27, 2012
3. Do I need to rewrite the boot ROM area using MI6C Flash Starter?

   Rewriting of the boot ROM area is unnecessary. This is because M3A-0806 performs programming using the standard boot program which was programmed into the boot ROM area when it was shipped. (#104963)

   Mar 1, 2005