EL7531

Monolithic 1A Step-Down Regulator with Low Quiescent Current

Product Status: Mass Production

OVERVIEW

The EL7531 is a synchronous, integrated FET 1A step-down regulator with internal compensation. It operates with an input voltage range from 2.5V to 5.5V, which accommodates supplies of 3.3V, 5V, or a Li-Ion battery source. The output can be externally set from 0.8V to VIN with a resistive divider.

The EL7531 features automatic PFM/PWM mode control, or PWM mode only. The PWM frequency is typically 1.4MHz and can be synchronized up to 12MHz. The typical no load quiescent current is only 120µA. Additional features include a Power-Good output, <1µA shut-down current, short-circuit protection, and over-temperature protection.

The EL7531 is available in the 10-pin MSOP package, making the entire converter occupy less than 0.15 in2 of PCB area with components on one side only. The 10-pin MSOP package is specified for operation over the full -40°C to +85°C temperature range.

KEY FEATURES

  • Less than 0.15 in2 (0.97 cm2) footprint for the complete 1A converter
  • Components on one side of PCB
  • Max height 1.1mm MSOP10
  • Power-Good (PG) output
  • Internally-compensated voltage mode controller
  • Up to 94% efficiency
  • <1µA shut-down current
  • 120µA quiescent current
  • Overcurrent and over-temperature protection
  • External synchronizable up to 12MHz
  • Pb-Free plus anneal available (RoHS compliant)

BLOCK DIAGRAM

 Block Diagram

PARAMETRICS

Parameters
EL7531
Basic Information
生产状态
Mass Production
输出数量
1
拓扑 [Rail 1]
Buck
输入电压最小值 (V) [Rail 1]
2.5
输入电压最大值 (V) [Rail 1]
5.5
输出电压最小值 (V) [Rail 1]
0.8
输出电压最大值 (V) [Rail 1]
5.5
输出电流最大值 (A) [Rail 1]
1
IQ [Rail 1]
120 µA
开关频率 (最大值) (MHz)
1.4
开关频率 (最小值) (MHz)
1.4
最大占空比 (%)
See Datasheet
资质级别
Standard
峰值效率 (%)
94
POR
Yes
BOM总占用面积 (mm2)
503.2
SYNCH功能
Yes
控制类型
Voltage Mode
开关频率范围 (MHz)
1.4
CAN 采样
YES
温度范围
-40 to +85

设计资源与工具

Selection Tool

 PowerCompass Online Tool

The PowerCompass™ tool helps you find Renesas parts that match your requirements, performs system analysis & more.

Design

Design Tool

 PowerNavigator Software

Configure and monitor digital-DC devices. Easily change features and functions of your power supply design with a simple GUI.

Design

Simulation Tool

iSim Online Designer

Select supporting components, build your schematic and validate your power management and op amp designs.

Simulate

Cross Reference

Intersil Cross Reference

Cross-reference based on data from industry sources. Support for the online tool has been discontinued, but the data is still available.

Download

Knowledge Base

Switching Regulators FAQs

Find answers to common questions, support articles and development hints.


FAQs

相关评估板与套件

Action Needed