ISL89164

High Speed, Dual Channel, 6A, Power MOSFET Driver with Enable Inputs

OVERVIEW

The ISL89163, ISL89164, and ISL89165 are high-speed, 6A, dual channel MOSFET drivers with enable inputs. These parts are very similar to the ISL89160, ISL89161, ISL89162 drivers but with an added enable input for each channel occupying NC pins 1 and 8 of the ISL89160, ISL89161, ISL89162.

Precision thresholds on all logic inputs allow the use of external RC circuits to generate accurate and stable time delays on both the main channel inputs, INA and INB, and the enable inputs, ENA and ENB. The precision delays capable of these precise logic thresholds makes these parts very useful for dead-time control and synchronous rectifiers. Note that the ENable and INput logic inputs can be interchanged for alternate logic implementations.

Three input logic thresholds are available: 3.3V (CMOS), 5.0V (CMOS or TTL compatible), and CMOS thresholds that are proportional to VDD.

At high switching frequencies, these MOSFET drivers use very little internal bias currents. Separate, non-overlapping drive circuits are used to drive each CMOS output FET to prevent shoot-through currents in the output stage.

The start-up sequence is designed to prevent unexpected glitches when VDD is being turned on or turned off. When VDD < ~1V, an internal 10kΩ resistor between the output and ground helps to keep the output voltage low. When ~1V < VDD < UV, both outputs are driven low with very low resistance and the logic inputs are ignored. This insures that the driven FETs are off. When VDD > UVLO, and after a short delay, the outputs now respond to the logic inputs.

KEY FEATURES

  • Dual output, 6A peak currents, can be paralleled
  • Dual AND-ed input logic, (INput and ENable)
  • Typical ON-resistance <1Ω
  • Specified Miller plateau drive currents
  • Very low thermal impedance (θJC = 3°C/W)
  • Hysteretic Input logic levels for 3.3V CMOS, 5V CMOS, TTL, and Logic levels proportional to VDD
  • Precision threshold inputs for time delays with external RC components
  • 20ns rise and fall time driving a 10nF load.

PARAMETRICS

Parameters
ISL89164
Basic Information
生产状态
Mass Production
驱动器数量
2
输入电压最大值 (V)
16
最大工作频率
10 MHz
峰值输出电流IPK
6 A
上升时间
20 ns
下降时间
20 ns
导通延迟 (ns)
25
关断延迟 (ns)
25
IS
5 mA
VBIAS (最小值)
4.5 V
RDS (ON)
2 Ω
输入信号范围 (V)
0 to VP
输入电源范围 (V)
+4.5 to +16
输出信号范围 (V)
0 to +16
资质级别
Standard
输入信号最大值 (V)
16
输入电源VP (最大值)
16 V
输入电源VP (最小值)
4.5 V
输出信号 (最大值) (V)
16
输出信号 (最小值) (V)
0
CAN 采样
YES
温度范围
-40 to +125

Confirm below disclaimers

Input Renesas account name and password