HIP4080A

80V/2.5A Peak, High Frequency Full Bridge FET Driver with Charge Pump and Input Comparators

Product Status: Mass Production(*)

OVERVIEW

The HIP4080A is a high frequency, medium voltage Full Bridge N-Channel FET driver IC, available in 20 lead plastic SOIC and DIP packages. The HIP4080A includes an input comparator, used to facilitate the "hysteresis" and PWM modes of operation. Its HEN (high enable) lead can force current to freewheel in the bottom two external power MOSFETs, maintaining the upper power MOSFETs off. Since it can switch at frequencies up to 1MHz, the HIP4080A is well suited for driving Voice Coil Motors, switching power amplifiers and power supplies.

HIP4080A can also drive medium voltage brush motors, and two HIP4080As can be used to drive high performance stepper motors, since the short minimum "on-time" can provide fine micro-stepping capability.

Short propagation delays of approximately 55ns maximize control loop crossover frequencies and dead-times which can be adjusted to near zero to minimize distortion, resulting in precise control of the driven load.

The similar HIP4081A IC allows independent control of all 4 FETs in a Full Bridge configuration.

KEY FEATURES

  • Drives N-Channel FET Full Bridge Including High Side Chop Capability
  • Bootstrap Supply Max Voltage to 95VDC
  • Drives 1000pF Load at 1MHz in Free Air at +50°C with Rise and Fall Times of Typically 10ns
  • User-Programmable Dead Time
  • Charge-Pump and Bootstrap Maintain Upper Bias Supplies
  • DIS (Disable) Pin Pulls Gates Low
  • Input Logic Thresholds Compatible with 5V to 15V Logic Levels
  • Very Low Power Consumption
  • Undervoltage Protection
  • Pb-Free Available as an Option

BLOCK DIAGRAM

 Block Diagram

PARAMETRICS

Parameters
HIP4080A
Basic Information
生产状态
Mass Production(*)
最大自举电源电压 (V)
95
VBIAS (最大值) (V)
15
峰值上拉电流
2.6 A
峰值下拉电流
2.4 A
导通传播延迟 (ns)
70
关断传播延迟 (ns)
50
上升时间
10 ns
下降时间
10 ns
输入逻辑电平
3.3V/TTL
电荷泵
Yes
资质级别
Standard
CAN 采样
YES
温度范围
-40 to +85

Action Needed