ISL22424

Dual Digitally Controlled Potentiometer (XDCP™), Low Noise, Low Power, SPI® Bus, 256 Taps

Product Status: Mass Production

OVERVIEW

The ISL22424 integrates two digitally controlled potentiometers (DCP), control logic and non-volatile memory on a monolithic CMOS integrated circuit.

The digitally controlled potentiometers are implemented with a combination of resistor elements and CMOS switches. The position of the wiper is controlled by the user through the SPI serial interface. Each potentiometer has an associated volatile Wiper Register (WRi) and a non-volatile Initial Value Register (IVRi) that can be directly written to and read by the user. The contents of the WRi control the position of the wiper. At power-up the device recalls the contents of the DCP's IVRi to the corresponding WRi.

The ISL22424 also has 13 General Purpose non-volatile registers that can be used as storage of lookup table for multiple wiper position or any other valuable information. The ISL22424 features a dual supply, that is beneficial for applications requiring a bipolar range for DCP terminals between V- and VCC.

Each DCP can be used as three-terminal potentiometer or as two-terminal variable resistor in a wide variety of applications including control, parameter adjustments, and signal processing.

KEY FEATURES

  • Two potentiometers in one package
  • 256 resistor taps
  • SPI serial interface with write/read capability
  • Daisy Chain Configuration
  • Shutdown mode
  • Non-volatile EEPROM storage of wiper position
  • 13 General Purpose non-volatile registers
  • High reliability
  • Endurance: 1,000,000 data changes per bit per register
  • Register data retention: 50 years @ T ≤ +55°C
  • Wiper resistance: 70Ω typical @ 1mA
  • Standby current <4µA max
  • Shutdown current <4µA max
  • Dual power supply
  • VCC = 2.25V to 5.5V
  • V- = -2.25V to -5.5V
  • 10kΩ, 50kΩ or 100kΩ total resistance
  • Extended industrial temperature range: -40ºC to +125ºC
  • 14 Ld TSSOP or 16 Ld QFN
  • Pb-free plus anneal product (RoHS compliant)

BLOCK DIAGRAM

 Block Diagram

PARAMETRICS

Parameters
ISL22424
Basic Information
生产状态
Mass Production
器件/通道数量
2
抽头数量
256
内存类型
Nonvolatile
总线/输出接口
SPI
阻抗选项 (kΩ)
10
供电电压Vcc (最小值) (V)
2.25
供电电压Vcc (最大值) (V)
5.5
供电电流Icc
0.5 µA
阻抗变化特性
Linear
VL最小终端电压
-5.5 V
VL最大终端电压
5.5 V
Wiper电流 (mA)
3
Wiper电阻 (Ω)
70
双电源范围 (V)
-2.25 to -5.5
最高工作温度
125 °C
端到端温度系数 (ppm/øC)
45
中点比率温度系数
4
特性
Daisy Chainable to minimize # I/0 pins on microcontroller, dual supply required
资质级别
Standard
供电电压Vcc范围 (V)
2.25 to 5.5
CAN 采样
YES
温度范围
-40 to +125

Action Needed