ISL78201

40V 2.5A Regulator with Integrated High-Side MOSFET for Synchronous Buck or Boost Buck Converter

Product Status: Mass Production

OVERVIEW

The ISL78201 is an AEC-Q100 qualified 40V, 2.5A synchronous buck or boost buck controller with a high-side MOSFET and low-side driver integrated. In Buck mode, the ISL78201 supports a wide input range of 3V to 40V. In Boost-Buck mode, the input range can be extended down to 2.5V and output regulation can be maintained when VIN drops below VOUT , enabling sensitive electronics to remain on during cold-cranking and start-stop applications.

The ISL78201 has a flexible selection of operation modes including forced PWM mode and an optional switch to PFM mode for light loads. In PFM mode, the quiescent input current is as low as 300µA and can be further reduced to 180µA with AUXVCC connected to VOUT under 12V VIN and 5V VOUT application. The load boundary between PFM and PWM can be programmed to cover wide applications.

The low-side driver can be either used to drive an external low-side MOSFET for a synchronous buck, or left unused for a standard non-synchronous buck. The low-side driver can also be used to drive a boost converter as a preregulator that greatly expands the operating input voltage range down to 2.5V or lower.

The ISL78201 offers the most robust current protections. It uses peak current mode control with cycle-by-cycle current limiting. It is implemented with frequency foldback undercurrent limit condition; in addition, the hiccup overcurrent mode is also implemented to guarantee reliable operations under harsh short conditions. The ISL78201 has comprehensive protections against various faults including overvoltage and over-temperature protections, etc.

KEY FEATURES

  • Buck mode: input voltage range 3V to 40V
  • Boost mode expands operating input voltage lower than 2.5V
  • Selectable forced PWM mode or PFM mode
  • 300µA IC quiescent current (PFM, no load); 180µA input quiescent current (PFM, no load, VOUT tied to AUXVCC)
  • Less than 5µA (MAX) shutdown input current (IC disabled)
  • Operational topologies
  • Synchronous buck
  • Non-synchronous buck
  • Two-stage boost buck
  • Noninverting single inductor buck boost
  • Programmable frequency from 200kHz to 2.2MHz and frequency synchronization capability
  • ±1% Tight voltage regulation accuracy
  • Reliable cycle-by-cycle overcurrent protection
  • Temperature compensated current sense
  • Programmable OC limit
  • Frequency foldback and hiccup mode protection
  • 20 Ld HTSSOP package
  • AEC-Q100 qualified
  • Pb-free (RoHS compliant)

BLOCK DIAGRAM

 Block Diagram

PARAMETRICS

Parameters
ISL78201
Basic Information
生产状态
Mass Production
输出数量
1
拓扑 [Rail 1]
Buck or Boost
输入电压最小值 (V) [Rail 1]
3
输入电压最大值 (V) [Rail 1]
40
输出电压最小值 (V) [Rail 1]
0.8
输出电压最大值 (V) [Rail 1]
36
输出电流最大值 (A) [Rail 1]
2.5
IQ [Rail 1]
300 µA
开关频率 (最大值) (MHz)
2.2
开关频率 (最小值) (MHz)
0.2
最大占空比 (%)
-
资质级别
Automotive
峰值效率 (%)
96
POR
Yes
SYNCH功能
Yes
控制类型
Current Mode
开关频率范围 (MHz)
0.2 to 2.2
温度范围
-40 to +105

Action Needed