ISL15102

Single Port, PLC Differential Line Driver

Product Status: Mass Production

OVERVIEW

The ISL15102 is a single port differential line driver developed for Power Line Communication (PLC) applications. The device is designed to drive heavy line loads while maintaining a high level of linearity required in Orthogonal Frequency Division Multiplexing (OFDM) PLC modem links.

The ISL15102 has a disable control pin (DIS). In Disable mode, the line driver goes into Low Power mode and the outputs maintain a high impedance in the presence of high receive signal amplitude, improving TDM receive signal integrity.
The ISL15102 has built-in thermal protection. When the internal temperature reaches +150°C (typical) the driver shuts down to prevent damage to the device.

An internal input CM buffer maximizes the dynamic range and reduces the number of external components in the application circuit.

The ISL15102 is supplied in a thermally-enhanced small footprint (4mmx5mm) 24 Ld QFN package. The ISL15102 is specified for operation across the -40°C to +85°C operating ambient temperature range.

KEY FEATURES

  • Single differential driver
  • Internal VCM
  • 90MHz signal bandwidth
  • 900V/μs slew rate
  • Single +8V to +28V supply, absolute maximum 30V
  • Supports narrowband and broadband DMT PLC
  • -86dB THD at 200kHz in to 50Ω line load
  • -70dB THD at 3MHz in to 50Ω line load
  • Control pin for enable/disable for TDM operation
  • Thermal shutdown

BLOCK DIAGRAM

 Block Diagram

PARAMETRICS

Parameters
ISL15102
Basic Information
生产状态
Mass Production
带宽 (MHz)
90
器件/通道数量
1
压摆率 (V/μs)
900
VS (最小值)
8 V
VS (最大值)
28 V
IS (每放大器)
21 mA
IBIAS
±3 µA
最大失调电压
±17 mV
IOUT
0.75 A
IOUT @ RL
0.2A @ 50Ω
VOUT (V)
20
轨到轨输入
No
轨到轨输出
No
热关断
Yes
启用
Yes
资质级别
Standard
CAN 采样
YES
温度范围
-40 to +85

Action Needed